DARK STAMPING PLATE 16 Article : DARK16

Product Images: Images are provided for reference only. Packaging, labeling, colors, size, design, or appearance may vary from the images shown due to manufacturer updates or product changes.

Ingredients: Manufacturers may change ingredients, formulas, or product information without prior notice. The information shown on this page is provided for convenience and may not always reflect the most current product formulation.

Please Note: Always review the product packaging, ingredient list, directions, warnings, and manufacturer information before using the product.

About the product:

DARK PLATE is a metal stamping plate for creating nail designs using the stamping technique. It features deep and precise engravings for easy work. A large selection of patterns allows you to quickly and effortlessly create any design.

DESCRIPTION:

• High-quality engraving ensures convenient use;
• Enables you to create even complex designs without drawing skills;
• Recommended to use with DARK STAMPING POLISH and DARK Stamping Stamper.

HOW TO USE:

1. Perform a manicure and apply base/gel or color, cure under a lamp;
2. If a sticky dispersive layer is present, remove it using DARK GEL CLEANSER;
3. Apply polish onto the plate, use the scraper to remove excess and transfer the design onto the stamper;
4. Transfer the design from the stamper onto the nail with a rolling or steady motion;
5. Finish with top coat (if the top coat runs off the design, first apply a thin layer of clear base, then the top coat).

WHY A DESIGN MAY NOT TRANSFER TO THE STAMPER:

1. The polish should not be too thick; use a sufficient amount of polish on the brush to cover the design;
2. Apply polish onto the plate in 1-2 strokes; the longer the application, the worse the transfer as the polish dries quickly;
3. Work with the scraper at approximately a 45-degree angle without pressing too hard to prevent removing too much polish from the pattern;
4. Scrape quickly (2-4 times is enough), avoiding broad movements over the entire plate;
5. Immediately set down the scraper and pick up the stamper - swift action is necessary as stamping polishes dry fast;
6. Transfer the design onto the stamper with a gentle rolling motion - do not press the stamper hard onto the plate, as excessive pressure will leave polish in the plate.